RouterBoard 2011UiAS-2HnD-IN (con fuente)

SBC-RB2011UiAS-2HnD , Router MikroTik RouterBoard 2011UiAS-2HnD-IN , • TX Power: 30dBm • Max Power Consumption: 11W • CPU: Atheros AR9344 600MHz • Memory: 128MB DDR2 SDRAM on board memory • Ethernet: Five (5) 10/100 Mbit Fast Ethernet ports with Auto-MDI/X, Five (5) 10/100/1000 Mbit Gigabit Ethernet ports with Auto-MDI/X • Wireless: 2HnD - Built in 2GHz dual chain 802.11b/g/n wireless device • LAN ports: 5  • miniPCI: 0 • Integrated Wireless: Yes • PoE: 8-28V DC on Ether1 • Voltage Monitor: Yes • PCB temperature sensor: Yes • CPU temperature monitor: No • Operating System: RouterOS • RouterOS License: Level5 • Extras: reset button, reset jumper, RJ45 serial port, powered micro-B USB connector

Nivel de stock: Disponible
Cod: LFSBC-RB2011UiAS-2HnD
$ 3985
u$s 221
Comprar

Financiación

 

 

 

 

RB2011UiAS-2HnD

The RB2011 is a low cost multi port device series, powered by RouterOS, a fully featured routing operating system which has been continuously improved for fifteen years. Dynamic routing, hotspot, firewall, MPLS, VPN, advanced quality of service, load balancing and bonding, real-time configuration and monitoring - just a few of the vast number of features supported by RouterOS. 

RouterBOARD 2011UiAS-2HnD has most features and interfaces from all our Wireless routers. It’s powered by the new Atheros 600MHz 74K MIPS network processor, has 128MB RAM, five Gigabit LAN ports, five Fast Ethernet LAN ports and SFP cage (SFP module not included!). Also, it features powerful 1000mW dual chain 2.4Ghz 802.11bgn wireless onboard, RJ45 serial port, microUSB port and RouterOS L5 license. 

There are two MMCX connectors for adding external antennas, so you can create powerful dual chain wireless backbone, AP or CPE unit. 

There is PoE output function for port #10 - it can power other PoE capable devices with the same voltage as applied to the unit. Maximum load on the port is 500mA. 

Tested and recommended to use with MikroTik SFP modules: S-85DLC05D, S-31DLC20D and S-35/53LC20D (not included)

Product specifications

Details
Product code RB2011UiAS-2HnD
CPU nominal frequency 600 MHz
CPU core count 1
Size of RAM 128 MB
10/100 Ethernet ports 5
10/100/1000 Ethernet ports 5
Wireless chip model AR9344-DC3A
Wireless standards 802.11b/g/n
Number of USB ports 1
Power Jack 8-28V DC
PoE in 8-28V DC on Ether1
Voltage Monitor Yes
PCB temperature monitor Yes
Dimensions 214mm x 86mm
Operating System RouterOS
Tested ambient temperature -35C to +65C
License level L5
CPU AR9344-DC3A
Max Power consumption 15W
SFP ports 1
USB slot type microUSB type AB
Number of chains 2
Suggested price $99.00

Performance test results

RB2011UiAS-2HnD AR9344 1G&100M all port test
Mode Configuration 1518 byte 512 byte 64 byte
kpps Mbps kpps Mbps kpps Mbps
Bridging none (fast path) 122.0 1,481.6 232.0 950.3 269.6 138.0
Bridging 25 bridge filter rules 83.6 1,015.2 86.0 352.3 87.6 44.9
Routing none (fast path) 122.0 1,481.6 210.0 860.2 226.9 116.2
Routing 25 simple queues 100.5 1,220.5 103.9 425.6 106.6 54.6
Routing 25 ip filter rules 56.8 689.8 59.6 244.1 60.5 31.0
  1. All tests are done with Xena Networks specialized test equipment (XenaBay),and done according to RFC2544 (Xena2544)
  2. Max throughput is determined with 30+ second attempts with 0,1% packet loss tolerance in 64, 512, 1518 byte packet sizes
  3. Values in Italic indicate that max throughput was reached without maxing out CPU, but because board interface configuration was maxed out
  4. Test results show device maximum performance, and are reached using mentioned hardware and software configuration, different configurations most likely will result in lower results
  5.  
Formulario de contacto